FALCON RIDGE Aero-Vent Lexan CF-ZFORCE-WD05 Instructions For Installation And Care

Windshield for cf moto z force

Download this manual

NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are

happy with the product before removing protective film. Once the film is removed you cannot return the product

Be sure to read these instructions thoroughly before opening and installing the CF Moto Z Force Aero-Vent

Lexan Windshield.

1. Check over the parts included in the cartons with the parts list shown below:

1 5/8" Loom Clamps

1" Stainless Steels Bolts

Stainless Steel Washers

Plastic Thumb Nuts

Large Stainless Washers

Large Rubber Washers

Lock Nuts

Slide Fasteners

38" Rubber Gasket

Lexan Vent Slider

Lexan Windshield

If any parts are damaged or missing please contact customer service at (800) 213-7981.

2. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by

peeling off the protective film. Next take the 38" piece of rubber gasket and starting at one end firmly

place across the bottom of the windshield. You may need to trim off excess gasket. The diagram below

show where to install the gasket.

3510-1 Port Jacksonville Pkwy, Jacksonville, FL 32226

Instructions for Installation and Care of CF Moto Z Force

Aero-Vent Lexan Windshield

CF-ZFORCE-WD05

800-213-7981

for a full refund.

8 each

9 each

5 each

4 each

1 each

Page 1 3510-1 Port Jacksonville Pkwy, Jacksonville, FL 32226 800-213-7981 Instructions for Installation and Care of CF Moto Z Force Aero-Vent Lexan Windshield CF-ZFORCE-WD05 NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film.
Page 2 3. Next install the sliding vent panel on the inside of the windshield as shown in the diagram below. To install slide fasteners push through holes with thumbs until it is completely through the hole in the windshield and locked in place. 4.
Page 3 5. Take the remaining hardware and install the windshield to the roll cage as shown in the diagram below. 6. The four clamps that hold the windshield across the top use the large stainless and rubber washers to hold the windshield on. The inside part of it uses a small washer and a lock nut. the following photo shows how it should look.
Page 4 Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.