Table of Contents
Advertisement
Reassembly
NOTICE
To prevent leaking, ensure that the proper repair
components are used for the appropriate series
pump. See Filter Cap Repair Kit, 24F975, page 31,
for more information.
To reassemble the built-in filter:
NOTE: Lubricate all o-rings before installation.
1. Install o-rings (22*, 25*) onto bottom filter cap (26).
Then use wrench to reassemble and tighten bottom
filter cap. Torque to 40-60 ft-lb (52-82 N•m).
311762ZAP
22* thin
25*
medium
26
TI8294a
2. Reassemble o-ring (59*) onto top filter cap (20).
Install strainer (23), and filter support (24) in top
filter cap. Then use wrench to install and tighten top
filter cap. Torque to 40-60 ft-lb (52-82 N•m).
thick
59*
23
pin hole
faces up
open end
down
NOTE: 36cc through 115cc Xtreme pump lowers no
longer use the short filter screens (23) or supports (24).
See page 31 for details.
Repair
20
pin faces
up
TI8464a
24
slot is on bottom
TI8402a
15
Advertisement
Table of Contents
