Table Of Contents; Meaning Of Signal Words; Important Safety Information; General Safety Rules For All Power Tools - Flex MS 1706 FR Instruction Manual

MS 1706 FR
Content
Meaning of signal words . . . . . . . . . . 3
Important safety information . . . . . . . 3
GENERAL SAFETY RULES
for all power tools . . . . . . . . . . . . . . . 4
SPECIFIC SAFETY RULES
AND SYMBOLS . . . . . . . . . . . . . . . . 6
Overview . . . . . . . . . . . . . . . . . . . . . 9
Supplied components . . . . . . . . . . . 10
Operating instructions . . . . . . . . . . 10
Maintenance and care . . . . . . . . . . 14
Warranty . . . . . . . . . . . . . . . . . . . . . 16

Meaning of signal words

DANGER
DANGER indicates a potentially
hazardous situations which, if ignored,
could result in death or serious injury.
CAUTION
CAUTION indicates a potentially
hazardous situations which, if not
avoided, may result in minor or
moderate injury, or may cause machine
damage.
NOTE
NOTE emphasizes essential
information.

Important safety information

Read and understand all of the safety
precautions, warnings and operating
instructions in the Instruction manual
before operating or maintaining this
power tool.
Most accidents that result from power
tool operation and maintenance are
caused by the failure to observe basic
safety rules or precautions. An accident
can often be avoided by recognizing
a potentially hazardous situation before
it occurs, and by observing appropriate
safety procedures.
Basic safety precautions are outlined in
" "
the SAFETY section of this Instruction
manual and in the sections which
contain the operation and maintenance
instructions.
Hazards that must be avoided to
prevent bodily injury or machine
damage are identified by WARNINGS
on the power tool and in this Instruction
manual.
NEVER use this power tool in a manner
that has not been specifically
recommended by FLEX.
Intented use
The wall chaser MS 1706 FR is
designed
- is designed for industrial
applications,
- for chasing and separating mineral
materials without the addition of
water
- for use with diamond cutting discs
and accessories which are indicated
in this manual or recommended by
the manufacturer.
Instruction manual
3