Depth Gauge; Operation - Makita HR5001C Instruction Manual

2
3
4
1. Lock button
2. Change lever
3. Pointer
4. "O" symbol
1
2
1. Change lever
2. Pointer
2
1

1. Depth gauge

2. Clamp screw

OPERATION

10
Bit angle (when chipping, scaling or demolishing)
003172
1
The bit can be secured at 12 different angles. To change the
bit angle, depress the lock button and rotate the change lever
so that the pointer points to the "O" symbol. Turn the bit to
the desired angle.
Depress the lock button and rotate the change lever so that
003176
the pointer points to the
bit is securely held in place by turning it slightly.
Depth gauge
003184
The depth gauge is convenient for drilling holes of uniform
depth. Insert the depth gauge into the hole in the grip base.
Adjust the depth gauge to the desired depth and then tighten
the clamp screw to secure the depth gauge.
NOTE:
• The depth gauge cannot be used at the position where
the depth gauge strikes against the tool body.
Hammer drilling operation
003200
Set the change lever to the
Position the bit at the desired location for the hole, then pull
the switch trigger. Do not force the tool. Light pressure gives
best results. Keep the tool in position and prevent it from slip-
ping away from the hole.
Do not apply more pressure when the hole becomes clogged
with chips or particles. Instead, run the tool at an idle, then
remove the bit partially from the hole. By repeating this sev-
eral times, the hole will be cleaned out and normal drilling
may be resumed.
symbol. Then make sure that the
symbol.