Torque Limiter - Makita HR5001C Instruction Manual

1
3
1. Change lever
2. Pointer
3. Lock button
1
1. Pointer
2. Change lever
Selecting the action mode
Rotation with hammering
003130
2
For drilling in concrete, masonry, etc., depress the lock but-
ton and rotate the change lever so that the pointer points to
the
Hammering only
003135
2
For chipping, scaling or demolition operations, depress the
lock button and rotate the change lever so that the pointer
points to the
chisel, etc.
CAUTION:
• Do not rotate the change lever when the tool is running
under load. The tool will be damaged.
• To avoid rapid wear on the mode change mechanism, be
sure that the change lever is always positively located in
one of the two action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque level is
reached. The motor will disengage from the output shaft.
When this happens, the bit will stop turning.
CAUTION:
• As soon as the torque limiter actuates, switch off the tool
immediately. This will help prevent premature wear of the
tool.
symbol. Use a tungsten-carbide tipped bit.
symbol. Use a bull point, cold chisel, scaling
7