Seecode 234934 Manual page 13

Only use the appliance in accordance with the instructions in this user manual. Do not attempt to
repair the appliance yourself. It must be repaired by a service centre or qualified repair facility. This
unit does not contain any user-serviceable parts.
Operating the SEECODE Foot Reflexology Massager
Plug the AC/DC adapter into a standard wall outlet. The power indicator light will flash to indicate
standby mode.
Then press the corresponding function buttons on the control panel or remote control.
Note: Remove the protective film from the control panel before use. The keys on the control panel
are touch-sensitive.
A> SWITCHING ON THE UNIT
Press the button to switch on the SEECODE foot reflexology massager.
The red indicator light shows that the unit is switched on and a beep sounds.
Note: The massager starts with the following default settings:
Compression and massage strength: „Low" / Sole and arch heat: „ON".
When the unit is switched off, the red light flashes for 15 minutes and then
switches off automatically.
B> TIMER
Press the button to select automatic switch-off after 10, 20 or 30 minutes. The default setting is
15 minutes.