Table of Contents
Advertisement
Operation System Installation
Windows NT Users Only
Select Install Software at the beginning of the CD and follow the instructions for installing the HDLC C32
driver located under Synchronous/Asynchronous software installation selection.
Sealevel Systems no longer includes a CD with Sealevel software and drivers with the products. Most
all of Sealevel's software and drivers are available on the website (www.sealevel.com). Sealevel's
Technical Support department can assist in downloading the correct driver and/or software for the
Route 56. Please contact Technical Support at
Technical Description
The Sealevel Systems ROUTE 56 adapter was designed for seamless integration into any ISA based system.
The ROUTE 56 adapter requires a 80286 or higher CPU, one IRQ, a 8 byte block of I/O address and a 16K
block of memory address. The memory range of this adapter is configured to reside in the lower 1Megabyte
of memory and appears to the system as a bank switched 16K window. The ROUTE 56 adapter's memory
range can be disabled allowing multiple adapters to share the same block of memory.
Features
Single channel high speed sync/async wide area network (WAN) interface
•
RS-232, RS-422/449, EIA-530, V.35 and RS-485 serial interface capability with versatile cabling
•
options
•
Multi-protocol capable including: PPP (point-to-point protocol), Frame Relay, X.25, high-speed
Async, Bi-Sync, Mono-Sync, HDLC, SDLC
•
Ideal for T1, Fractional T1, E1, and ISDN applications
On-board Z16C32 (IUSC™) with built in DMA controller and 32 byte FIFO buffer
•
Up to 10 Mbps burst mode
•
256K of on-board RAM
•
•
Link list DMA supported
•
16-bit data path
© Sealevel Systems, Inc.
5011 Manual | SL9167 12/2022
support@sealevel.com
for further information.
9
Advertisement
Table of Contents
