Table of Contents
Advertisement
Introduction
Overview
The ROUTE 56 adapter provides the PC with a single channel high-speed multi-protocol serial interface
suitable for the most popular communication protocols. This sync/async card provides an ideal solution
for high-speed applications including LAN/WAN connectivity. Utilizing the Z16C32 (IUSC™) on chip DMA
controller eliminates bus bandwidth constraints that are placed on typical PC interface adapters, allowing
data rates to reach 10M bps in burst mode. By utilizing the Z16C32's 32 byte FIFO buffer coupled with 256K
of on board memory, higher data rates are achieved without increasing processor overhead.
What's Included
The ROUTE 56 is shipped with the following items. If any of these items are missing or damaged, contact
the supplier.
ROUTE 56 Adapter
•
Factory Default Settings
The ROUTE 56 factory default settings are as follows:
Base Address
300
To install the ROUTE 56 using factory default settings, refer to Installation on page 5.
For your reference, record installed ROUTE 56 settings below:
Base Address
© Sealevel Systems, Inc.
5011 Manual | SL9167 12/2022
IRQ
Default Electrical Interface
5
RS-530/422
IRQ
Default Electrical Interface
4
Advertisement
Table of Contents
