Supermicro X12SPi-TF User Manual page 91

sSATA Port 0/1/2 SATA Device Type
Use this feature to specify if the SATA port specified should be connected to a Solid State
Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
Network Configuration

Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unified Extensible
Firmware Interface) for network stack support. The options are Disabled and Enabled.
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and Enabled.
IPv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. The options are Disabled and Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and Enabled.
IPv6 HTTP Support
Select Enabled to enable IPv6 HTTP boot support. The options are Disabled and Enabled.
PXE Boot Wait Time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.
Media Detect Count
Use this option to specify the number of times media is checked. Press "+" or "-" on your
keyboard to change the value. The default setting is 1.
MAC:xxxxxxxxxxxx-IPv6 Network Configuration
MAC:xxxxxxxxxxxx-IPv6 Network Configuration
Enter Configuration Menu

Interface Name
Interface Type
MAC Address
Host addresses
Route Table
91
Chapter 4: BIOS