Table of Contents
Advertisement
Maintenance
The MasterPipe Compact Profiler is designed to offer consistent cut quality, when maintained. Cut quality and
repeatability are dependent on routine maintenance of the mechanical system of the machine as well as proper
plasma consumable use, and a clean reliable air supply. For maintenance details and consumable replacement
schedules please refer to the plasma cutter owners manual. The following maintenance should be performed on
the mechanical system after every 40 hours of use.
Use dry graphite on the wear parts, as petroleum products will collect metal dust and cause premature
mechanical wear.
1.
Clean and lubricate hinge parts on the floating chuck.
2.
Clean chuck assembly (compressed air)
3.
Tighten X-Belt
4.
Lubricate rotating ground
5.
Clean and lubricate Y-Rail assembly and bearings (compressed air)
6.
Remove debris from the ball transfer cradles(compressed air)
7.
Clean AVHC assembly (compressed air)
8.
Clean out cable track (compressed air)
2
3
1
Vernon Tool MasterPipe Compact Profiler
Maintenance
5
4
Page 31
6
8
7
Advertisement
Table of Contents
