Performing a Test Cut:
Setup the job:
In the PROCESS SETUP tab:
•
Set the Material type to Mild Steel
•
Set the Thickness to .216
•
Set the Current to 60
Load a piece of 3" Schedule 40 pipe into the machine at least 12" long.
Verify the installed consumables are for 60 or 65 amps (depending on your model FlexCut plasma cutter.)
Set the amperage on the FlexCut power supply to match the loaded consumables and the Process Setup tab in the VMD
software.
Set the air pressure output on the plasma cutter to match the Plasma Pressure on the Process Setup tab (consult the
plasma cutters users manual for specific instructions to properly set the Plasma Pressure.)
In the AVHC tab:
•
Set the Cut Parameters to Program Defined
•
Set the Sample Voltage to On
•
Set the IHS mode to Always
•
Set the AVHC mode to Auto
•
Set the IHS to Off
User Guide
Page 28