Assembly; Operation - Husqvarna 120iTK4-H Operator's Manual

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the shaft
1. Make sure that the electrical plugs are aligned. (Fig.
29)
2. Connect the ends of the shaft (A) fully.
3. Tighten the screw handle on the hedge trimmer head
side of the shaft (B).
To adjust the length of the shaft
1. Loosen the screw handle at the battery housing side
of the shaft (A). (Fig. 30)
2. Adjust the shaft to an applicable length.
3. Tighten the screw handle (B).
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
Introduction
WARNING:
safety chapter before you use the product.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
1553 - 008 - 31.10.2022

Assembly

Read and understand the

Operation

Read and understand the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
• Only use original spare parts.
• Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is roughly level with your right hip. (Fig. 31)
To install the battery charger (40-C80)
on the wall
CAUTION:
Do not use an electric
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary. (Fig.
32)
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
11