3.4 Memory
The X13SAE supports up to 128GB of DDR5 Unbuffered DIMM (UDIMM) ECC/non-ECC with
speeds of up to 4400MHz.
Note: Check the Supermicro website for recommended memory modules.
Important: Exercise extreme care when installing or removing DIMM modules to pre vent
any possible damage.
General Guidelines for Optimizing Memory Performance
•
When installing memory modules, the DIMM slots should be populated in the following
order: DIMMA2, DIMMB2, then DIMMA1, DIMMB1.
•
For optimal performance, use DDR5 memory of the same type, size, and speed.
•
Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed of the
slowest DIMM.
•
The motherboard supports odd-numbered modules (one or three modules installed).
However, to achieve the best memory performance, a balanced memory population is
recommended.
AUDIO_FP
JPAC1
COM1
USB2/3
JTPM1
PCI-E M.2-M2
SP1
JF1
JD1
JPME2
JLED1
BT1
JSTBY1
PCI-E M.2-M1
JSD1
JL1
JWD1
I-SATA0
I-SATA1
Chapter 3: Maintenance and Component Installation
BMC_HB_LED
JPL2
MAC CODE
BMC CODE
BAR CODE
BIOS LICENSE
X13SAE
REV:1.00
DESIGNED IN USA
MAC CODE
DIMMA1
DIMMA2
DIMMB1
DIMMB2
PCH
JBT1
USB11 (USB3.2 (20Gb))
I-SATA2
I-SATA4
I-SATA6
I-SATA3
I-SATA5
I-SATA7
AUDIO
LAN2
LAN1
USB0/1
USB8/9 (3.2 (10Gb))
USB7 (3.2 (10Gb))
USB10 (3.2 (20Gb))
JPL1
PCI-E M.2-M3
CATERR_LED
USB4/5 (USB3.2 (5Gb)) USB6 (USB3.2 (5Gb))
SYS_FAN2
28
DP
DVI
HDMI
CPU_FAN1
JPW2
CPU_FAN2
12V_PUMP_PWR1
DIMMA1
DIMMA2
DIMMB1
DIMMB2
JPI2C1
SYS_FAN1
JPW1