Honeywell MILLER 81004170 User Instruction Manual page 11

Precautions before use
Before using, a visual and tactile inspection of the device must be carried out to
make sure that it is in a satisfactory operating condition.
Before any use, check:
That the markings are legible and that the product labels are in good condition.
The user of the device must read the recommendations relating specifically to each
component to be used with the SÖLL TOTEM DURAHOIST POST MILLER (harnesses,
lanyards, karabiners, etc.) and ensure compliance and correct use.It is essential to
verify before using, each time, that there is a suitable minimum clearance in case
of a fall (observing the presence of any obstacle or obstruction that presents a
hazard in a fall situation).
Check that the anchorage device that you have just bought is compatible with the
recommendations for the other components of the fall protection system and that
their safety features do not interfere with each other.
Warning!
In the event of a fall being stopped by the SÖLL TOTEM DURAHOIST POST
MILLER, the anchorage collar may have been subject to deterioration. If there
is any doubt as to its integrity, the anchorage collar must not be used until the
device is checked either by the manufacturer, an approved body or an
accredited and competent person.
The SÖLL TOTEM DURAHOIST POST MILLER can only be used together with the
following safety accessories:
• For work presenting a risk of falling, fall arrest systems in compliance with
standard EN 363 and shock absorbers in compliance with standard EN 355;
retractable lifelines EN 360.
• As part of a workplace restraint system, in compliance with standard EN 358
• Rescue system in compliance with standards EN 1496, 1497 and 1498.
Danger!
The lanyard karabiner (EN 362) or the safety block (EN 360) must not be re-
moved from the anchorage device before the user is protected from falls via
other means.
D - UPKEEP AND MAINTENANCE
D1. The SÖLL TOTEM DURAHOIST POST MILLER is manufactured from
aluminium and the anchorage rings in 316 grade stainless steel. The bolt-on
or weld-on bases are in 316 grade stainless steel that does not require any
special care.
D2. For safety purposes, never repair components. Damaged components (e.g.
after a fall) must always be replaced.
D3. Only original spare parts or those approved by the manufacturer can be used
for purposes of replacement.
D4. Warning!
An anchorage device that is faulty or has stopped a fall cannot continue
to be used. It can be reused only if a competent person has approved it for
subsequent use.
11