Parts Description - Makita DVC560 Instruction Manual

PARTS DESCRIPTION

► Fig.1
1 Handle
5 Indication panel
9 Lock (for battery cover)
13 Round brush
17 Suction hose
21 LED lamp
25 OFF button
29 Indicator for remaining
battery capacity
ASSEMBLY
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge
is removed before carrying out any work on the
appliance.
CAUTION:
Always wear dust mask during
assembly or maintenance.
Handle connecting
1. Insert the handle pole fully to the cleaner body as
shown in the figure.
2. Close the lock latch.
► Fig.2: 1. Handle pole 2. Red marking 3. Lock latch
NOTICE:
Insert the handle fully until the red
marking cannot be seen.
Hose connecting
Insert the hose into the mounting port of the appliance
and turn the horse until it locks.
► Fig.3
Pipe connecting
Insert the tip of the aluminum pipe to the joint, and then
attach the aluminum pipe to the pipe holder.
► Fig.4: 1. Joint 2. Pipe holder
NOTICE:
Insert the aluminum pipe in correct
direction as shown in figure. Otherwise the pipe
holder will not be locked and the aluminum pipe may
come off.
► Fig.5
2 Switch plate
6 Lever (for the dust box
cover)
10 Adjusting lever
14 Foot lever
18 Joint
22 Brushroll
26 Indicator of oparating
mode
30 Battery check / LED
lamp button
12 ENGLISH
3 Pipe grip
7 Dust box cover
11 Battery cover
15 Caster wheel
19 Aluminum pipe
23 Bottom plate
27 Indicator of excess level
of dust
- -
Installing or removing battery cartridge
CAUTION:
Always switch off the appliance
before installing or removing of the battery
cartridge.
CAUTION:
Hold the cleaner and the battery
cartridge firmly when installing or removing bat-
tery cartridge. Failure to hold the cleaner and the
battery cartridge firmly may cause them to slip off
your hands and result in damage to the cleaner and
battery cartridge and a personal injury.
CAUTION:
Be careful not to pinch your fin-
gers when opening or closing the battery cover.
Failure to do so may cause personal injury.
To install the battery cartridge, release the lock first, and then
open the battery cover. After that, insert the battery cartridge.
► Fig.6: 1. Lock 2. Battery cover
Align the tongue on the battery cartridge with the groove in the
housing and slip it into place. Insert it all the way until it locks
in place with a little click. Then lock the battery cover.
► Fig.7: 1. Battery cartridge 2. Button
To remove the battery cartridge, slide it from the appli-
ance while sliding the button in front of the cartridge.
CAUTION:
Always install the battery cartridge
fully. If not, it may accidentally fall out of the appli-
ance, causing injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: The cleaner does not work with only one
battery cartridge.
Installing the filter bag
CAUTION:
Do not use a damaged filter bag.
Always use the vacuum cleaner with the filter bag
properly installed. Otherwise the vacuumed dust or
particles may be exhausted from the cleaner and
they may cause respiratory disease to the operator.
4 Hose
8 Carrying handle
12 Corner nozzle
16 Side brush
20 Pipe holder
24 ON / mode change
button
28 Indicator of brushroll
error
- -