DeFelsko PosiTector 200 Instruction Manual page 8

Ultrasonic coating thickness gage

Hide thumbs Also See for PosiTector 200:

Table of Contents

Adjust Thickness Option

Adj Thickness

Select a reference standard of material as close as

possible in composition to the intended application.

For best results, the thickness of the reference stan-

dard should be equal to or slightly greater than the

thickness of the coating to be measured.

1. Apply a drop of couplant onto the reference stan-

dard.

2. Measure the reference standard.

3. Lift the probe. Select the Adj Thickness menu

option.

4. Adjust the display down (-) or up (+) to the

reference standard thickness.

5. Press

to store the adjustment. Standard

models will exit.

6. Advanced models with more than 1 layer selected

will continue to the next layer. Adjust the thickness

(step 4) and store the adjustment by pressing

When all layers have been adjusted, the gage will

exit the Adj Thickness option.

Note: A Reset (pg.11) will restore factory settings.

Table of Contents

Need help?

Do you have a question about the PosiTector 200 and is the answer not in the manual?