Advertisement
Available languages
Available languages
13.
Use of the lock
• To start, touch the numeric panel
• Press "*" the key and then "#".
• You will hear "Add admin." Enter your fingerprint six times or enter a password twice, followed by
the "#" key.
• The voice assistant will provide a menu with four options:
1. Add user: press "1" to add a user.
• You will hear the message "Add user".
Enter your fingerprint or numeric password:
• To save a fingerprint, touch the fingerprint sensor six times.
• To add a numerical password of 6 to 8 digits, you must enter it twice and confirm with "#".
2. Delete user: press "2" to delete a user.
• You will hear the message "Delete user".
Enter the fingerprint or numeric password you wish to delete:
• To erase the fingerprint touch the fingerprint sensor, then you will hear the fingerprint registration
number. Press "#" to confirm.
• To delete a numeric password, you must enter it followed by the "#" key, then press "#" again to
confirm.
3. Lock setting: press "3" to access the lock configuration. The assistant will provide you with a menu
with three options:
1. Function setting: press "1" for function settings. The assistant will provide you with a menu with
three options:
1. Enable/Disable passage: press "1" to activate/deactivate the conventional mode. If this mode is
activated the lock will remain open after each opening, so press "#" to lock the door. If disabled, it
will automatically close 5 seconds after each opening. You can also activate or deactivate this mode
by pressing and holding the "LOCK" button on the rear handle for 5 seconds.
2. Enable/Disable dual verify: press "2" to activate/deactivate the double unlocking function. If this
function is enabled, you will need two unlocking methods to open the door (password + password,
fingerprint + fingerprint, password + fingerprint). Only administrator passwords or fingerprints will
be able to unlock without double verification.
3. Enable/disable mute: press "3" to activate/deactivate the keyboard mute mode.
2. Volume setting: press "2" to adjust the assistant and keypad volume.
• 1. Volume up: press "1" to turn up the volume.
• 2. Volume down: press "2" to turn down the volume.
3. Language setting: press "3" for language selection.
• "1. Chinese" (Press "1" for Chinese)
• "2. English" (Press "2" for English)
30
Advertisement
