DEMA IMPERIA Operation And Maintenance Manual page 35

2. Brightness
Set display brightness. Briefly press (<0.5S) + or - to select "Brightness" and then briefly press (<0.5S)
. This moment, briefly press (<0.5S) + or - to switch the percentage as 100%/75%/50%/30%/10%.
100% is the highest brightness, 10% is lowest brightness. After select the brightness percentage,
briefly press (<0.5S) again to save the set and exit back to "Brightness".
3. Auto Off
Set automatic Off time. Briefly press (<0.5S) + or - to select "Auto Off", and then briefly press
(<0.5S) . This moment switch automatic Off time as OFF/9/8/7/6/5/4/3/2/1. The unit is
minute. After selection, briefly press (<0.5S) to save the set and exit back to "Auto Off".
4. Power View
Set output display mode. Briefly press (<0.5S) + or - to se-
lect "Power View", and then briefly press (<0.5S) . This mo-
ment, briefly press (<0.5S) + or - to switch the output display
mode as "Power"/"Current". After confirmation, briefly press
(<0.5S) again to save the set and exit back to "Power View".
5. SOC View
Set indication mode for battery capacity. Briefly press (<0.5S) +
or - to selcet "SOC View", and then briefly press (<0.5S) . This
moment switch display mode for output as "Percent"/"Voltage".
After confirmation, briefly press (<0.5S) to save the set and exit back to "SOC View".
6. TRIP Reset
Set reset function for single-trip distance. Briefly press (<0.5S) + or - to select "TRIP Reset", and then
briefly press (<0.5S) . This moment, briefly press (<0.5S) + or - to switch between "NO"and"YES".
TRIP Reset includes maximum speed (MAXS), average speed (AVG), single-trip distance (TRIP).
After confirmation, briefly press (<0.5S) again to save the set and exit back to the "TRIP Reset".
7. AL Sensitivity
Set light sensitivity. Briefly press (<0.5S) + or - to select "AL Sensitivity", and then briefly press
(<0.5S) . This moment switch level of the light sensitivity between 0/1/2/3/4/5/OFF. "OFF"
means close the function. Level 1 is the weakest light sensitivity and level 5 is the strongest
light sensitivity. Select the level desired and briefly press (<0.5S) again to save the setting
and exit back to "AL Sensitivity".
8. Password
Access password setting. Briefly press (<0.5S) + or - to select "Password" and then briefly press
(<0.5S) . This moment select "Start PassWord" and then briefly press (<0.5S) again. Briefly
press (<0.5S) + or - to switch between "OFF"/"ON", the below is the specific way of switching.
Starting password:
Enter into "Start PassWord" interface and select "ON". Briefly press (<0.5S) , and then it show
input password in the interface. This moment switch numbers "0-9", and then briefly press (<0.5S)
to confirm input number. After input, it show input password again in the interface. Repeat the
above step to input password again. If the password is same with the previous time, the system
will prompt it is successful to set password. After setting the passwrod, the interface exit back
automatically to original interface within two seconds.
E-bike operation and maintenance manual EN 35