System Event Log - Avalue Technology HPS-621UTA Quick Reference Manual

Item
BMC Support
Wait For BMC
FRB-2 Timer
FRB-2 Timer timeout
FRB-2 Timer Policy
OS Watchdog Timer
Power Control Policy
3.6.3.1

System Event Log

Options
Enabled[Default]
Disabled
Enabled
Disabled[Default]
Enabled[Default]
Disabled
3 minutes
4 minutes
5 minutes
6 minutes[Default]
Do Nothing[Default]
Reset
Power Down
Power Cycle
Enabled
Disabled[Default]
Do Not PowerUp
Last Power State
Power Restore
Unspecified[Default]
Quick Reference Guide
Description
Enable/Disable interfaces to communicate with BMC.
Wait For BMC response for specified time out. BMC
starts at the same time when BIOS starts during AC
power ON. It takes around 30 seconds to initialize
Host to BMC interfaces.
Enable or Disable FRB-2 time (POST timer).
Enter value Between 3 to 6 min for FRB-2 Timer
Expiration value.
Configure how the system should respond if the FRB-2
Timer expires. Not available if FRB-2 Timer is
disabled.
If enabled, starts a BIOS timer which can only be shut
off by Management Software after the OS loads. Helps
determine that the OS successfully loaded or follows
the OS Boot Watchdog Timer policy.
Configure how the system should respond if AC Power
is lost, Reset not required as selected Power policy will
be set in BMC when policy is saved.
HPS-621UTA Quick Reference Guide 63