Table of Contents
Advertisement
Faults and what to do about them
en
:
Warning
Risk of injury!
Reaching into the drum while it is still
turning may cause hand injuries.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
Turn the programme selector to Off.
1.
Pull out the mains plug.
Open the service flap.
2.
Information on the display panel
Display
Õ
r
E lights up
44
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with Start/Reload/Pause button or
select Drain.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 43
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required ~ separate installation and cleaning
instruction for water filter.
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Drain the water. ~ Page 41
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
Advertisement
Table of Contents
