Table of Contents
Advertisement
Your appliance has an intelligent dosing
system for liquid detergent and fabric
softener.
The optimum quantities of liquid
detergent and fabric softener are
dispensed automatically depending on
the programme and settings.
Automatic dosing is activated at the
factory for all the designated
programmes and it can be adjusted to
suit your requirements. The settings are
saved when the appliance is switched
off.
For programmes in which automatic
dosing is not possible, you can add
suitable detergent to the compartment
in the detergent drawer for manual
dosing.
Ž i-DOS Detergent drawer
( w dispenser for liquid detergent
0 © dispenser for fabric softener
8 Manual dosing compartment
Before setting up Ž i-DOS
Follow the manufacturer's instructions
when choosing your detergent and care
product. We recommend using easy-
pour, all-purpose, universal and colour
liquid detergents for all machine-
washable, coloured items made of
cotton or synthetic fabrics.
Notes
Only use easy-pour liquid products
■
that the manufacturer recommends
adding to the detergent drawer.
Intelligent dosing system
When cleaning the Ž i-DOS
■
detergent drawer, empty the
dispenser completely and clean it.
~ Page 38
Do not mix detergent and fabric
■
softener.
Do not use products containing
■
solvents, caustic agents or volatile
substances (e.g. bleach).
Do not use products that have
■
expired or are highly congealed.
Automatic dosing
The automatic dosage operates as
follows:
Switch on the appliance.
1.
A function test of the Ž i-DOS pump
unit takes place, and this can be
detected by a brief noise in the Ž i-
DOS detergent drawer.
Select a programme with Ž i-DOS
2.
settings.
When the Ž i-DOS setting for
detergent and fabric softener is
active, the corresponding symbols
light up in the display.
Start the programme.
3.
The drum rotates and, depending on
the programme selected, load
detection takes place (takes up to 2
minutes). Depending on the load
detected, the required quantities of
detergent and fabric softener (in the
last wash cycle) are then dosed,
which can be detected by a pump
noise.
Automatic dosing can be activated or
deactivated for each of the designated
wash programmes separately.
Automatic dosing can also be activated
or deactivated once the programme has
started, although this depends on which
stage the programme is in.
To activate/deactivate automatic
dosing, press Ž i-DOS briefly. The
setting is saved until the next time it is
changed.
en
35
Advertisement
Table of Contents
