Creating Custom Paper Settings
You can create and store up to 30 custom paper settings for use in printing on non-Epson paper or paper
that is not supported by the Epson printer driver.
1. Load the type of paper that you want to configure in the printer.
2. Select
3. Select a number for the custom paper setting.
Note: You cannot change paper setting information registered using the printer driver or other
software using the LCD screen.
4. Select Change Reference Paper.
5. Select a paper preset that is similar to the paper that you loaded following these guidelines:
• Photo paper: Baryta
• Fine art paper: Fine Art Matte
• Canvas: Satin Canvas or Matte Canvas
• Plain paper: Plain Paper
• Glossy paper: Photo Paper
• Thick, non-glossy paper: Matte Paper
• Thin, soft, non-glossy paper: Plain Paper
• Canvas-like paper: Canvas
• Cotton paper with a rough surface: Fine Art Paper
• Special media such as film, cloth, poster board, or tracing paper: Others
6. Select Advanced Paper Settings and enter a value for the following settings:
• Paper Thickness
• Roll Core Diameter (roll paper only)
• Paper Feed Offset (leave at 0 unless you see horizontal banding)
Note: The Paper Feed Offset setting allows you to adjust the difference between the data size and
the print size. For example, if you are printing at a data size of 3.9 inches (100 mm) and a print
size of 4 inches (101 mm), the offset is 1.0%. Therefore, you would enter a value of -1.0%.
> General Settings > Printer Settings > Custom Paper Setting.
110