Lcd Screen Safety Instructions - Epson SureColor T7770D Series User Manual

• Do not use the printer in locations with volatile substances such as alcohol or thinner, or near naked
flames. An electric shock or fire could occur.
• Do not use the product if it is giving off smoke or if you notice any abnormal odors or noises. An
electric shock or fire could occur. If any abnormalities occur, turn off the power and unplug the power
cable immediately, then contact your dealer or Epson Support.
• Only route the cables as indicated in the User's Guide. When connecting cables or optional
accessories, make sure they are installed in the correct direction and that you follow the procedures
exactly.
• Pay careful attention when replacing the cutter and store the cutter in a location out of the reach of
children. The cutter's blade could cause an injury.
• When opening and closing the bottom tray of the print stacker, keep your hands away from the joints
between the tray and the stacker itself.
Note: The lithium batteries in this product contain Perchlorate Material - special handling may apply.
Click here for details.
Parent topic:

LCD Screen Safety Instructions

• Use only a dry, soft cloth to clean the LCD screen. Do not use liquid or chemical cleansers. Never use
volatile chemicals such as thinner, benzene, or alcohol. Doing so could damage the surface of the
control panel.
• If the panel is particularly dirty, dampen the cloth with water containing a small amount of neutral
detergent, firmly wring the cloth dry before using it to wipe the panel, and then finish by wiping with a
soft, dry cloth.
• If the LCD screen is damaged, contact Epson. If the liquid crystal solution gets on your hands, wash
them thoroughly using large volumes of soapy water. If the liquid crystal solution gets into your eyes,
flush them with clean water for at least 15 minutes. If discomfort or vision problems remain after a
thorough flushing, see a doctor immediately. If liquid enters your mouth, see a doctor immediately.
• Do not press too hard on the LCD screen or subject it to heavy impacts.
• Use only your finger to operate the LCD screen; it may not respond when operated with wet fingers or
gloved hands.
• Do not use a pointy or sharp object, such as a pen or your fingernail, to operate the LCD screen.
• Make sure to remove the protective film from the LCD screen before operating; otherwise it may not
respond.
Important Safety Instructions
374