Switching On The Printer - AGFA Drystar AXYS User Manual

Switching on the printer

Follow the procedure below to ensure proper start-up of the printer and to
check that everything is working correctly.
1. Check that the power cord is plugged in and then switch on the printer by
pressing the Power/Reset button.
On the display, the following message is displayed. After a short while, a
progress indicator will show the progress of the self-test.
2. The printer is ready for operation:
• If, on the front panel display, the READY message is shown, the status
indicator LED is constantly green.
• If, on the front panel display, the print queue screen is shown, the
status indicator LED is green and blinking.
Note: Before switching on the printer, read the safety
instructions.
Note:
It takes 9 minutes before the printer can start printing.
After 6 minutes the READY message appears and from
then on you can send print jobs to the printer, but it will
take another five minutes for the printer head to heat up.
When you send print jobs to the printer during this five
minutes, the printer will use that time to calculate the
print job and the display will inform you that the printer
is warming up.
Drystar AXYS | Introduction | 69
2852D EN 20161128 1416