Switching On The Printer - AGFA Drystar 5500 User Manual

66 | Drystar 5500, Drystar 5503 | Introduction

Switching on the printer

Follow the procedure below to ensure proper start-up of the printer and to
check that everything is working correctly.
1. Check that the power cord is plugged in and then switch on the printer by
pressing the Power button.
On the display, the following message is displayed. After a short while, a
progress indicator will show the proceeding of the self test.
2. The printer is ready for operation:
• If, on the front panel display, the READY message is shown, the status
• If, on the front panel display, the Print queue screen is shown, the
2901J EN 20191018 0826
Note: Before switching on the printer, read the safety
instructions.
indicator LED is constant green.
Note: It takes 11 minutes before the printer can start
printing. After 6 minutes the READY message appears
and from then on you can send print jobs to the printer,
but it will take another five minutes for the printer head
to heat up. When you send print jobs to the printer
during this five minutes, the printer will use that time to
calculate the print job and the display will inform you
that the printer is warming up.
status indicator LED is green and blinking.