Programming Mode - Mitel MiVoice 4223 Office Directions For Use Manual

M V 4223 O
I OICE FFICE
10.10.2
10.10.3
105
(DBC 223) M V
FOR I OICE
• Press C , * and 7 simultaneously during at least 1 second
A tone signal is heard, and the display shows (example):
Note: The soft-keys and the Activate/deactivate information text are only available
when firmware revision R3F or later is active for the telephone. See Firmware
indication to check the firmware revision.
11.10 Firmware indication on page 113
To exit Melody mode
Press the soft-key Exit or press #.
•
If no key is pressed for 30 seconds, the telephone returns to idle. In this case nothing
is stored. Also 10.10.5 To save a melody on page 108 .

PROGRAMMING MODE

To enter
• Press the soft-key Program , or the top function key.
The top function key lamp is turned on, and the display shows:
Note: The soft-key and the Program/edit,delete information text are only available
when firmware revision R3F or later is active for the telephone. See Firmware
indication to check the firmware revision.
11.10 Firmware indication on page 113
SELECT RINGING TYPE
To select the wanted ringing type to program, press Line 1, Line 2 or Inquiry for
Internal call, External call or Call Back respectively. The corresponding LED starts
flashing.
The display shows the corresponding programmed melody (the default melodies are
shown as examples - when no melody is stored, only the cursor (<) is shown):
MX-ONE
3/1553-ANF 901 54 Uen F5 2018-12-03