User Interface Events That Will Terminate A Remote Session - Fluke OptiView III Series Getting Started Manual

User Interface Events that will Terminate a Remote Session

The active TCP/IP session between the user interface software and the analyzer can be severed under the
following conditions:
IP parameters are manually changed on the analyzer and Apply is selected in the Management port TCP/
IP setup screen
The following conditions only apply to the Network 10/100/1000 and 1000BASE-X
fiber ports, and not to the Management port.
Auto Reconfigure on Network Change is checked in the TCP/IP setup screen and the analyzer patch
cable is disconnected and reconnected to another jack
The Ethernet link goes down on either interface due to temporary network outage
Rerun Auto Configure is selected in the TCP/IP setup screen
Find Unused IP and Apply is selected in the TCP/IP setup screen
IP parameters are manually changed and Apply is selected in the TCP/IP setup screen
Rerun Cable Test is selected
If the Analyzer MAC address is changed in the Setup | Ethernet screen
If Receive only, do not transmit frames is selected in the Setup | Ethernet screen
Accessing the Analyzer through the Remote User Interface Software
Note
Workgroup Analyzer
11