Manual Control - Claas JAGUAR 8500 C Service Parts

Hydraulic / Electric System

1.3.1 Manual control

Switching on manual
control:
Key functions when
manual control is active
Folding up the rear rotors
Lowering the rear rotors
Folding up the front rotors
Lowering the front rotors
Increasing the front swath
width
Decreasing the front swath
width
Raising/lowering the
chassis
Notes:
4-14
LINER
Manual control is used for diagnosis purposes.
Individual functions (valves) are checked.
Press key 3 (working position) and key 6 (front swath width)
simultaneously for approx. 7 seconds.
The flashing mode of LED 10 changes.
Press key 4 (transport position).
Press key 3 (working position).
Press key 7 (fold up front rotors).
Press key 8 (lower front rotors).
Press key 5 (increase working width)
Press key 6 (decrease working width)
Press key 9 (turning area) and hold it (chassis is raised or lowered).
•
All functions only work as long as the corresponding key is pressed.
•
When the control unit is in this mode, all safety circuits are shut
down. When the swather is in working position, do not lower the
chassis!
•
After shutting down the control unit, it will resume normal operation
when switching it on the next time.
TIC
10/04