Operation; Display And Operating Elements - Samson Media 6 Mounting And Operating Instructions

Operation

Table 3 · Overview of functions for software limit switches A1 and A2 at connector B
Proximity switch
for ...
(gas tapping / tank filling)
Alarm contact
Value falls below
High resistance Low resistance High resistance High resistance Low resistance Low resistance
limit
Value exceeds
Low resistance High resistance Low resistance Low resistance High resistance High resistance
limit
The limit switches A1 and A2 can be separately configured to function as min or max alarms.
Low-resistance contact
Switching signal "ON" · Function: contact closed or output effectively conducting,
power consumption ≥ 3 mA
High-resistance contact
Switching signal "OFF" · Function: contact open or output effectively non-conducting,
power consumption ≤ 1 mA
4 Operation

4.1 Display and operating elements

All necessary data and measured values saved in the memory of Media 6 are indicated on the
LCD.
The operating elements are located on the bottom panel behind the protective cover, which can
be opened:
Up key
Down key
Enter key
Apart from that, four DIP switches to select the gas type and write protection functions (also see
page 22) are included.
Further details on the display and operating elements can be found on the fold-out page at the
end of these instructions.
18
EB 9527-3 EN
1 min/1 max contact
A1 A2
2 min contacts
(gas tapping)
A1 A2
2 max contacts
(tank filling)
A1 A2