Table of Contents
Advertisement
can create a software power down. In a software power down, the system can
be resumed by Wake Up Alarms. This item lets you install a software power
down that is controlled by the power button on your system. If the item is set
to Instant-Off, then the power button causes a software power down. If the
item is set to Delay 4 Sec. then you have to hold the power button down for
four seconds to cause a software power down.
Power State Resume Control (Always Off)
This sets the power state after a shutdown due to an unexpected interrupt of
AC power.
PM Wake Up Events
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
IRQ [3-7, 9-15], NMI
IRQ 8 Break Suspend
Ring/WOL/WOM PowerUp Control
MACPME Power Up Control
PCIPME Power Up Control
USB S3 WakeUp Function
PS2KB Wakeup from S3
PS2MS Wakeup from S3
Power Up by Alarm
x
Month Alarm
x
Date (of Month)
x
Time (hh:mm:ss)
** Reload Global Timer Events **
Primary IDE
Secondary IDE
FDD, COM, LPT Port
PCI PIRQ[A-D]#
↑ ↓ → ← : Move
Enter : Select
F5:Previous Values
This item opens a submenu that enables you to set events that will resume
the system from a power saving mode.
IRQ [3-7, 9-15], NMI (Enabled)
This option determines whether any activity for IRQ 3-7/9-15 will cause the
system to wake from a power saving mode.
IRQ 8 Break Suspend (Disabled)
Determines whether the system will monitor IRQ 8 activity and wake the sys-
tem from a power saving mode when IRQ 8 is activated.
Ring/WOL/WOM PowerUp Contl (Disabled)
Use this item to enable LAN or modem activity to wakeup the system from a
power saving mode.
PM Wake Up Events
[Enabled ]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Hot Key]
[Disabled]
[Disabled]
NA
0
0 0 0
[Disabled]
[Disabled]
[Disabled]
[Disabled]
+/-/PU/PD:Value:
F10: Save ESC: Exit
F6:Fail-Safe Defaults
F7:Optimized Defaults
45
Item Help
Menu Level
F1:General Help
Advertisement
Table of Contents
