Dell PowerProtect DM5500 Installation Manual page 21

Data manager appliance

Hide thumbs Also See for PowerProtect DM5500:

Table of Contents

1. Cage nut (2)

2. Screws (2)

3. Chassis retention bracket

NOTE:

The chassis shown in the image is not representative of a specific system.

To install each chassis retention bracket, perform the following steps.

Steps

1. Place the bracket on the system.

2. Secure the bracket to the rack flange with two screws by using Phillips #2 screwdriver.

The installed chassis bracket on each rack flange should look like the following image.

NOTE:

Do not overtighten the retention brackets; keeping them slightly loose will make it easier to insert the system

under them when positioning the system on the rails.

Install the DM5500 in the rack

Table of Contents