Table of Contents
Advertisement
Beamage-M² User Manual
APPENDIX B. RECYCLING AND SEPARATION PROCEDURE FOR WEEE
This section is used by the recycling center when the Beamage-M² reaches its end of life. Breaking the
calibration seal or opening the Beamage's case will void the warranty.
The complete Beamage-M² contains:
1 Beamage-4M camera
1 USB 3.0 cable with screw locks
1 BNC to SMA connector
1 Software USB key
3 Circular 2" Al-coated mirrors
1 Square 2" Al-coated mirror
2 Moving stages
1 48 V power supply
1 USB 2 cable
3 2" ND filters
4 Mirror mounts
1 Aluminum housing with mounting pieces
3 Lenses, 2"
3 Lens holding tubes, 2"
SEPARATION
Plastic: Aperture cap, SMA cap, USB key housing
Metal: Beamage case, screws, SMA connector, BNC to SMA connector, ND filter holders, mirror holders,
Beamage-M² casing, connector plate, mirror posts, lens holding tubes
Wires: USB cables, power supply
Printed circuit board: Inside the Beamage-4M and inside the electrical moving stage
Glass: ND filters and mirrors
DISMANTLING PROCEDURE
Remove all housing screws.
Separate the round mirrors from their mounts by unscrewing their holding screws.
Remove the square mirror by sliding a fine flat head screwdriver behind it.
Remove the 2" ND filters and the 2" lenses with a spanner wrench.
Use a Philips screwdriver to unscrew the electrical moving stage's circuit housing.
Remove the PCB and motor.
Unscrew the #10-32 set screw to remove the Beamage-4M camera.
Unscrew every other screws to completely unmount the assembly.
For the Beamage camera:
Remove the 3 screws on the BEAMAGE's back cover with an Allen key (1/16'').
Remove the 1 screw holding the PCBs with a flat screwdriver.
Cut the wire between the PCB and the SMA connector.
Remove the ND filter and remove the glass with a spanner wrench.
Revision 6
50
Advertisement
Table of Contents
