Figure 5-30: Data Section; Figure 5-31: Calculate M² Button - Gentec Beamage M2 User Manual

Beamage-M² User Manual
Click on any data on the list to select it. When the camera is not streaming, the corresponding beam
measurement will be shown on the Display panel.
•
The values X diameters and Y diameters are calculated according to the
chosen definition 4 sigma (ISO) or 1/e
change the definition from 4 sigma (ISO) to 1/e² along crosshairs (13.5%) or
vice versa, at any time, but when the measurement is in progress. These
diameters will be recalculated automatically and updated on the list.
•
If the Beamage is not streaming, you can select a row in the list using the mouse
and the image corresponding to this measurement will be shown in all displays.
The row index corresponds to the image index (see Figure 5-5: Image Index).
When the camera is not streaming, click any data row in the list and the corresponding beam image will
Calculate M² button
Clicking this button forces the calculation of the beam parameters based on the acquired data and makes
PC-Beamage switch to M² Results tab and M
Revision 6
Tip
2
along crosshairs (13.5%). You can

Figure 5-30: Data section

show in the Display panel.
2
display.
Figure 5-31: Calculate M² button
30