M² Images Controls; Button; Figure 5-2: M 2 Images Controls; Figure 5-3: M 2 Button - Gentec Beamage M2 User Manual

Beamage-M² User Manual
5.1. M² IMAGES CONTROLS
The PC-Beamage software saves the images of each beam slice on the hard drive of your computer. These
images facilitate the analysis of the results by allowing the user to consult them once the measurement is
completed.
The PC-Beamage Software provides an automatic management of the
*.bmg files saved on the hard drive which will be used for the calculation
2
of M . These files will be deleted every time the application starts up or
2
5.1.1. M

button

2
The M button activates the M
button is inactive. Upon successful connection, the stage will move the carrier to the "far" end of the
2
the M
rail (far from the lens), and the other buttons will become clickable.
It is not necessary to have a connected camera to use the M
more information, please see the "load a *.m2man file" section.
Revision 6
2
Figure 5-2: M Images controls
every time you use the "Clear all" button.
2
mode by giving access to the M
Figure 5-3: M
Tip
2
Results and M
2
button
Tip
2
2
Setup panels. By default,
mode. For
17