Figure 3-4: Software Setup : Step 5; Figure 3-5: Select The Action Following The Setup Phase - Gentec Beamage M2 User Manual

Beamage-M² User Manual
5. Under M² Setup, fill in the Laser Wavelength and Focal Length fields.
6. Click RUN M² SETUP.
7. Click Yes to automatically start an M² measurement once the SETUP phase is completed.
8. Execute the tasks required to obtain good measurement conditions during the setup phase. The
software might show pop-up windows when one of the following actions is required:
a. Change lens
b. Add attenuation
c. Remove attenuation
Figure 3-4: Software setup: step 5.

Figure 3-5: Select the action following the setup phase

Revision 6 11