Gentec Beamage M2 User Manual page 3

Beamage-M² User Manual
Do not use a Beamage-M² if the device or the detector appears damaged, or if you suspect that a Beamage-M² is
not operating properly.
Note: This equipment has been tested and was found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, try to correct the interference by taking one or more of the following steps:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment to an outlet that is on a different circuit than the receiver.
•
Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved in writing by Gentec-EO Inc. may void the
user's authority to operate this equipment.
Revision 6
SAFETY INFORMATION
ii