Operation - Summit ALFZ51 Instruction Manual

the top of the door. (Fig.2)
5. Remove the bottom support bracket from the right side. (Fig.3)
6. Remove the top right hinge and keep in a safe place in case you want to reverse the door in the future.
(Fig.4)
7. Remove the screws from the top left and transfer to the right.
8. Install the top left hinge. (Fig.5)
9. Install the bottom left hinge to the door. Do not over-tighten the screw.
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket. (Fig.6)
12. Adjust door alignment. When set, tighten the screw on the hinge.
13. Remove the handle. Transfer the screw hole covers to the left and install the handle on the right.
NOTE: Some variations of this unit's door may not be reversible in the field. For more information, visit
our website.
The appliance should be placed where the ambient temperature is between 50~100°F (10~38°C). If the
ambient temperature is above or below this range, the performance of the unit may be affected. Placing
your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate.
Connect the power cord to a properly grounded outlet.
This appliance is equipped with Memory IC – should there be a power interruption, the unit will auto-recover
at the last setting.
Control Panel:
ON/OFF Power
To turn the appliance on or off, press and hold the ON/OFF button for 3 seconds.
Setting the Temperature Control
Adjustable temperature: 14°F to -22°F (-10°C to -30°C)
Set the desired cooling temperature by pressing the corresponding button
buttons will raise or lower the temperature setting by 1 degree. The temperature selected will flash in the
LED display for approximately 5 seconds, then revert back to displaying the temperature of the cabinet
interior.
°C/°F Temperature Conversion
This unit has the option of displaying temperatures in either Celsius or Fahrenheit. To change the setting, press
the °C/°F button.
Fast Freeze Function

OPERATION

7
or . Each press of the