olympia electronics BS-506/LITHIUM Quick Start Manual

Battery Replacement

1. Remove smoke alarm from mounting plate following Step 1 of the
Installation Instructions.
2. Clean the device as described in maintenance paragraph.
3. Replace the old batteries by a new pair. Use recommended batteries for
more reliable operation.
4. Place the smoke alarm on the Mounting plate and secure it by turning it
clockwise.
5. Test the correct operation of your smoke alarm as described in Device Test
paragraph. If no sound is generated, the smoke alarm must be replaced
immediately!

Recycling and Desposal

The WEEE symbol means that this product and batteries must be disposed
separately from other household waste. When they reach their end of
life, take them to a designated waste collection point in your area to
guarantee a safe disposal or recycling. Protect the environment, human
health and natural resources!

Troubleshooting

False alarm is often caused by dust or steam.
After a batteries replacement, the device performs an auto-adjusting process
in 8 hours period to establish its operation. If false alarm happens within this
period, it is important to clean the smoke alarm as described in maintenance
paragraph.

Technical Characteristics

POWER SUPPLY Replaceable batteries: 2x AA Lithium FR6 (L91)
BATTERY LIFE
SMOKE CONCENTRATION SENSITIVITY
INDICATORS
Optical and Acoustic > 85dB (A) at 3 m
ALARM SILENCE FACILITY
LOW BATTERY WARNING
LOW BATTERY SILENCE FACILITY
MOUNTING LOCATION
INTERCONNECTABLE
DETECTION METHOD
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
EXTERNAL DIMENSION
WEIGHT
GUARANTEE
3 years (1 year for the battery)
4
Signaling Overview
Operating Mode
NORMAL
TEST
ALARM
Hush
Alarm Memory
LOW BATTERY
Fault Warning
BS-506/LITHIUM
Battery Operated
Smoke Alarm
EN 14604:2008
DoP: 921506001_59_001

Warranty

Olympia Electronics guarantees the quality, condition and operation of the
BS-506/LITHIUM
goods. The period of warranty is specified in the official catalogue of Olympia
Electronics and also in the technical leaflet, which accompanies each product.
10 years
This warranty ceases to exist if the buyer does not follow the technical
0.110 dB/m
instructions included in official documents given by Olympia Electronics or if the
buyer modifies the goods provided or has any repairs or re-setting done by a third
Yes
party, unless Olympia Electronics has fully agreed to them in writing. Products
Yes
that have been damaged can be returned to the premises of our company for
Yes
repair or replacement, as long as the warranty period is valid.
Ceiling
Olympia Electronics reserves the right to repair or to replace the returned goods
No
and to or not charge the buyer depending on the reason of defection. Olympia
Optical
Electronics reserves the right to charge or not the buyer the transportation cost.
IP20
EN14604-2008
o
0 to 45 C
Up to 93%
ABS/PC, PC
Ø130 x 43 mm
185gr.
5
921506001_09_007
Visible indication
Acoustic Signal
(flashes)
1 Red per 344 sec None
functioning properly
Alarm pattern
1 Red per sec Device under test
1 Red per sec Alarm Pattern Smoke detected
None
1 Red per 10 sec
decreased sensitivity
3 Yellow per 43 sec None
1 short signal
None Replace batteries
per 43 sec
3 short signals
None
per 43 sec
1922
21
EGINIO
PIERIAS
60300
GREECE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
info@olympia-electronics.gr
921506001_09_007
European
manufacturers
Comment
Device
9 min
Exited an
alarm mode
Replace the
smoke alarm
BS-506/LITHIUM
BATTERY OPERATED
Battery
Life
IP20 10 years Optical
Thank you for your trust in our products
Olympia Electronics - European manufacturer
SMOKE ALARM
EN14604
2008
85dB