Installation; Installing The Communication Module - Danfoss VLT MCD 200 Installation Manual

Modbus TCP Module
Installation Guide

3 Installation

3.1 Installing the Communication Module

EQUIPMENT DAMAGE
If mains and control voltage are applied when installing or removing options/accessories, it may damage the equipment.
-
Remove mains and control voltage from the soft starter before installing or removing options/accessories.
Procedure
1.
Remove control power and mains supply from the soft starter.
2. Fully pull the top and bottom retaining clips on the module.
8 | Danfoss A/S © 2022.11
C A U T I O N
Installation
AN428736661763en-000101 / 175R1189