ADT ADC-V523 Installation Manual page 5

|
3 Connecting Your Camera to Wi-Fi
Before we can proceed with any of the camera set up steps, it is critical that your
camera is connected to your property Wi-Fi network.
There are 2 ways to do this, please follow the instructions for either Connecting in
Wi-Fi Protected Setup (WPS) Mode or Connecting in Access Point (AP) Mode.
4.A
Wi-Fi Protected Setup (WPS) Mode
Use WPS mode to connect the camera to
your network by physically pressing down
on the WPS button on your internet router
You can also follow along step by step by using our video tutorial found here:
https://www.adtsecurity.com.au/panel/wifi-cameras/. Also refer to troubleshooting
and FAQs found in this Installation Guide if you experience any trouble.
4.A Connecting in Wi-Fi Protected Setup (WPS) Mode
1. Connect AC power adapter and plug into an outlet
2. Hold down the Reset button
3. Press the WPS Button on the router. The router will connect to the wireless
network. The connection is complete once the LED turns solid green.
4. Follow the instructions under Enrolling Your Camera on your ADT Interactive
Account
4.B
Access Point (AP) Mode
Use AP mode to use wireless internet
to connect the camera to your network
until the LED is flashing blue (3 seconds)
5