Korg iM1 Owner's Manual page 45

INSERT FX
There are two Insert effects available for every Timbre in a
Combi.
Refer to M1 owner's manual PDF, page 36 "3 - Effect parame-
ters"
IFX............................................................................................... [OFF, ON]
This switch acts as a bypass, turning the entire Insert effect
section On or Off.
This setting is linked with the Timbre Parameter "IFX."
OFF (dark): The Insert effects will not be heard (bypassed).
ON (lit): The Insert effects will be heard (active).
ROUTING TYPE ............................................................... [SERIAL, PARALLEL]
This parameter determines how the two Insert effects are
routed.
SERIAL sends the output of one Insert effect to the input of
the other Insert effect.
PARALLEL allows the two Insert effects to operate indepen-
dently, side by side.
The Routing Type can only be selected when the OSC
MODE (page 29) is set to DRUMS. In this case, there are
two stereo buses available. When the OSC MODE is set
to SINGLE or DOUBLE, only one stereo bus is avail-
able, the Routing Type is set to Serial, and PAN controls
are inserted between FX1 and FX2.
Available Parameters by Mode
FX 1/FX 2.......................................................................................[OFF, ON]
Each Insert effect can be turned on or off individually.
PAN ON/OFF ..................................................................................[OFF, ON]
This parameter switches the pan On and Off.
If this setting is OFF, the signals will not be sent.
If you've turned PAN off in DRUM mode and then
change the OSC MODE to SINGLE or DOUBLE, you
will need to turn the PAN controls on again in order to
hear any sound.
PAN ................................................................................[L50...C00...R50]
This parameter sets the panning of busses A and B when the
OSC MODE is set to SINGLE or DOUBLE.
When the OSC MODE is set to DRUMS, this parameter will
control the panning of busses C and D.
MIXER..................................................................................[---, Main, Sub]
Use this parameter to choose the output.
FX 1/FX 2
EFFECT TYPE......................................... [No Effect, Reverb...Delay/Tremolo]
Tap here to select the Master effect type, including No Effect.
Effect Parameter
Each Insert effect type will have its own specific set of adjustable
parameters. For the effects that were added in the iM1 for iPad,
refer to Effect Parameters on page 23.
45