PIAGGIO NRG 50 User Manual page 143

NRG 50
Engine
- Heat the flywheel-side crankcase half with a ther-
mal gun.
- Keeping the crankcase half on the transmission
side, fit the flywheel side crankcase half with a
clean precise movement
- Insert at least three fastening screws and tighten
up rapidly
- Fit and tighten the other screws, applying the
recommended torque.
- Move the crankcase separation plate into a re-
tracted position.
- Install the special magnetic support with dial
gauge at the end of the crankshaft
Specific tooling
020335Y Magnetic mounting for dial gauge
ENG - 143