Advertisement
Available languages
Available languages
Quick Links
Printed Matter No.9836 1814 00
Publication Date 2022-10-13
Valid from Serial No. -
Rapid Backup Unit PF4000
To reduce risk of injury, everyone using, installing, repairing, main-
taining, changing accessories on, or working near this tool MUST
read and understand these instructions before performing any such
task.
DO NOT DISCARD - GIVE TO USER
RBU Installation guide
WARNING
Control and drive unit
Instruction Supplement
Advertisement
Related Manuals for Atlas Copco RBU
Summary of Contents for Atlas Copco RBU
- Page 1 RBU Installation guide Printed Matter No.9836 1814 00 Control and drive unit Publication Date 2022-10-13 Valid from Serial No. - Instruction Supplement Rapid Backup Unit PF4000 WARNING To reduce risk of injury, everyone using, installing, repairing, main- taining, changing accessories on, or working near this tool MUST read and understand these instructions before performing any such task.
- Page 2 Table of Contents Instruction Supplement ................... 3 Dodatek do instrukcji obsługi ................. 5 © Atlas Copco Industrial Technique AB - 9836 1814 00...
- Page 3 RBU memories. For example if the Power Focus and RBU memories do not match, you have to choose if you want to use the configuration stored in the Power Focus or the RBU. If the power Focus and the RBU are incompatible for other reasons than configuration mismatch, either the Power Focus or RBU is referred to (in the table below) as NOK.
- Page 4 RBU memories. Otherwise se- lect “Stop”. If no RBU is detected the error codes 805 (PF Model unknown) and 433 (no RBU present) will appear on the display. Acknowledge the errors, turn the power off and connect the RBU. © Atlas Copco Industrial Technique AB - 9836 1814 00...
- Page 5 Power Focus i modułu RBU. Jeśli na przykład pamięci sterownika Power Focus i modułu RBU nie są do siebie dopasowane, użytkownik musi wybrać, czy chce zastosować konfigurację zapisaną w pamięci sterownika Power Focus, czy w pamięci modułu RBU.
- Page 6 „Stop”. Jeśli nie zostanie wykryty żaden moduł RBU, na wyświetlaczu pojawi się kod błędu 805 (nie- znany model PF) i kod 433 (brak modułu RBU). Należy wówczas potwierdzić błędy, wyłączyć zasilanie i podłączyć moduł RBU.
- Page 8 Original instructions Tłumaczenie oryginalnej instrukcji © Copyright 2022, Atlas Copco Industrial Technique AB. All rights reserved. Any unauthorized use or copying of the contents or part thereof is prohibited. Atlas Copco Industrial This applies in particular to trademarks, model denominations, part numbers Technique AB and drawings.