Starting The Engine - Ford EVEREST 2009 Manual

EVEREST_F8M7-10-09B_Edition1 Page93
Tuesday, February 10 2009 12:54 AM
ON
This is the normal running position after
the engine is started. The warning lights
should be inspected before the engine is
started (page 5-32).
NOTE
(Petrol engine models)
When the ignition switch is turned to
the ON position, the sound of the fuel
pump motor operating near the fuel
tank can be heard. This does not
indicate an abnormality.
START
The engine is started in this position. It
will crank until you release the key; then
it returns to the ON position.
qIgnition Key Reminder
If the ignition switch is in the LOCK or
ACC position with the key inserted, a
continuous beep sound will be heard
when the driver's door is opened.
Form No.F8M7-10-09B
Black plate (93,1)
Starting and Driving

Starting the Engine

Petrol engine
1. Occupants should fasten their seat
belts.
2. Make sure the parking brake is on.
3. Depress the brake pedal.
4. Depress the clutch pedal all the way
and shift into neutral.
Keep the clutch pedal depressed while
cranking the engine.
5. Turn the ignition switch to the START
position and hold (up to 10 seconds at
a time) until the engine starts.
CAUTION
Do not try the starter for more than 10
seconds at a time. If the engine stalls or
fails to start, wait 10 seconds before
trying again. Otherwise, you may
damage the starter and drain the battery.
6. After starting the engine, let it idle for
about 10 seconds.
Driving Your Ford
5-3