Ford EVEREST 2009 Manual page 126

EVEREST_F8M7-10-09B_Edition1 Page126
Tuesday, February 10 2009 12:54 AM
Driving Your Ford
Warning/Indicator Lights and Beep Sounds
CAUTION
Do not run the engine if the oil pressure
is low. It could result in extensive
engine damage.
qCheck Engine Light
This indicator light illuminates when the
ignition switch is turned to the ON
position and goes off when the engine is
started.
If this light comes on while driving, the
vehicle may have a problem. It is
important to note the driving conditions
when the light came on and consult an
expert repairer, we recommend an
Authorised Ford Repairer.
The check engine light may come on in
the following cases:
The engine's electrical system has a
l
problem.
The emission control system has a
l
problem.
If the check engine light remains on, do
not drive at high speeds and consult an
expert repairer, we recommend an
Authorised Ford Repairer as soon as
possible.
í
5-36
Some models.
Form No.F8M7-10-09B
If the low fuel warning and check
engine lights illuminate at the same
time (3.0L TDCi and 2.5L TDCi)
The check engine light may illuminate if
air enters the fuel lines such as when the
fuel tank is nearly empty.
Bleed the air from the fuel lines using the
í
following procedure to turn off the light.
1. Refuel until the low fuel warning light
2. Pump the priming pump on the upper
3. Start the engine and continue driving
4. Turn off the engine and wait about 10
5. The check engine light turns off when
6. If the light remains illuminated, repeat
If the check engine light remains
illuminated even after performing the
above procedure, consult an expert
repairer, we recommend an Authorised
Ford Repairer.
Black plate (126,1)
turns off (about 10 liters or more).
part of the fuel filter to bleed out the
air.
Refer to Running Out of Fuel on page
7-19.
for about 10 seconds while the engine
is idling normally.
seconds.
the engine is started after repeating
Steps 3 and 4 three times.
Steps 2 to 5 again.