Chapter 3: Installing The Printserver Using The Setup Wizard; Before You Begin; Installation; Figure 3-1: Welcome - Linksys WPSM54G User Manual

Wireless-g printserver with multifunction printer support

Hide thumbs Also See for WPSM54G:

Table of Contents

Wireless-G PrintServer with Multifunction Printer Support

Chapter 3: Installing the PrintServer Using the

Setup Wizard

HAVE YOU: already set up your printer? Linksys recommends that you set up your printer and

install your printer's driver before you install the PrintServer's driver.

Note the PrintServer's default name, which starts with "LK" (for example, LK71107). It is shown in the Server field

on the sticker located on the PrintServer's back panel. During the Setup Wizard, this name is used to identify the

PrintServer you are currently installing.

To install the PrintServer, you will use the Setup CD-ROM to run the Setup Wizard. It is highly recommended that

you use a computer on the wired network to set up the PrintServer. However, if you only have a wireless network,

then you can use a computer on the wireless network to set up the PrintServer.

1. Insert the Setup CD-ROM into the computer's CD-ROM drive. The Setup Wizard should run automatically. If it

does not, click the Start button and choose Run. In the box that appears, enter D:\SetupWizard.exe (if "D" is

the letter of your CD-ROM drive).

2. When you see the Welcome screen, click Click Here to Start to begin the installation. Click Exit to end the

installation. Click User Guide button to view the User Guide.

3. If this is the first time you have installed the PrintServer, click Set up PrintServer. If you have already

installed and configured the PrintServer, click Set up Computer and proceed to "Chapter 4: Installing the

PrintServer Driver."

Chapter 3: Installing the PrintServer Using the Setup Wizard

Before You Begin

Table of Contents