Figure 5-8: Auto-Disconnect (Time); Figure 5-9: Auto-Disconnect (Always Connect) - Linksys WPSM54G User Manual

Wireless-G PrintServer with Multifunction Printer Support
Auto-Disconnect
By default, the computer will be disconnected three minutes after the scan, print job, or fax is completed. To
make changes, click the Change button. To change the length of time before the computer is disconnected from
the printer, select the appropriate length of time from the drop-down menu, and then click the Set button. If you
want the computer to always be connected to the printer, such as when you have only one computer using the
Figure 5-8: Auto-Disconnect Figure 5-9: Auto-Disconnect
printer, click Always connect, and then click the Set button.
(Time) (Always Connect)
Print Server Settings
This section shows you the PrintServer's settings, which were configured during the Setup Wizard.
If you will use the PrintServer's web-based utility, write down the IP address of the PrintServer. You will need it to
access the web-based utility.
Diagnostic
To run the wizard that sets up the PrintServer driver, click the Diagnostic button. Refer to "Chapter 4: Installing
the PrintServer Driver" for details.
Close
To close the Print Server Information screen, click the Close button.
If you would like to change the PrintServer's advanced settings, use the web-based utility. For more
information, refer to "Chapter 6: Using the Web-based Utility".
Chapter 5: Using the Diagnostic Utility 23
About the Print Server Information Screen