Linksys WPS54G Quick Installation

®
A Division of Cisco Systems, Inc.
Package Contents
• Wireless-G PrintServer
• Setup Wizard CD-ROM
• User Guide on CD-ROM
• USB 2.0 Cable
• Network Cable
• Power Supply
• Quick Installation
• Registration Card
2.4
GHz
Wireless-G
802.11g
PrintServer
Wireless Quick Installation
Model No.
WPS54G
Model No.
1
Connect the PrintServer
Before starting the physical
installation, note the PrintServer's
default name. The default name is
shown in the Server field on the
sticker located on the PrintServer's
back panel.
A
Use the USB cable to connect
your USB printer to the
PrintServer's USB Printer port.
A
B
If you are connecting the
PrintServer to your wired
network, then plug one end of
the Ethernet network cable into
the PrintServer's Ethernet port.
Then connect the other end to
your router or switch.
C
C
Power on your printer.
D
Plug the power adapter into
the PrintServer's Power port.
Then plug the other end into
an electrical outlet.
D
2
Configure the PrintServer
A
Insert the Setup CD-ROM into
the computer's CD-ROM drive.
The Setup Wizard should run
automatically. If it does not,
click Start and choose Run. In
the field that appears,
enter D:\setupWizard.exe (if
"D" is the letter of your
CD-ROM drive).
B
On the Welcome screen, click
Setup Wizard.
B
C
The Setup Wizard will search for
the PrintServer. After it has been
found, the Wireless-G
PrintServer Setup screen will
appear. If this is the first time
you have run the Setup Wizard,
make sure that List only new
(unconfigured) Print Servers is
selected and your PrintServer is
listed by its default server
C
name. If you have previously
configured the PrintServer,
select List all compatible Print
Servers. Click Next.
D
On the Basic Settings screen,
you may change the Device
Name and Domain Name
settings if you want. Then
click Next.
D
E
The IP Settings screen will
appear. If your network uses a
router that automatically
assigns IP addresses, select
Automatically obtain an IP
address (DHCP) and click
Next. If you need to assign the
PrintServer a static IP address,
select Set IP configuration
manually, and enter the IP E
Address, Subnet Mask, and
Gateway in the fields provided.
Then click Next.
F
On the Set PrintServer's
Password screen, enter the
PrintServer's default password,
admin, in the Current
Password field. Enter a new
password in the New Password
field, and enter it again in the
Verify Password field.
Click Next.
F
G
On the Wireless Settings
screen, enter your wireless
network's SSID or name. If your
network is set to ad-hoc mode,
select the channel at which
the network broadcasts its
wireless signal. For the Network
Type setting, select
infrastructure if the PrintServer
will communicate using an
G
access point or wireless router.
Select Ad-Hoc if the PrintServer
will communicate directly with
wireless-equipped computers.
Click Next.