Turning Off The Device; Overheat Protection; Tilt Protection; Maintenance, Cleaning And Storage - Silvercrest SHL 2000 A1 Manual

If the desired temperature is not reached, turn
back the temperature regulator 4 counter-
clockwise until you hear a clear click. The
control light 3 goes out. Then an integrated
thermostat controller will automatically turn the
heating function ON or OFF.
Please note: When the thermostat is in the MIN
position, the device remains completely OFF.

4.3 Turning OFF the Device

Set the heating level switch 2 on the "Fan"
position and wait 30 seconds to allow the
heating elements to cool down. Damage to the
device could occur if not observed.
Set the heating level switch 2 at position "0".
Pull the power plug out of the socket.
Before you cover the device or put it away,
wait until it has cooled down.

4.4 Overheat Protection

This device is equipped with an overheating
protection If the device is too hot, the heating ele-
ment switches off automatically.
Turn the device OFF by turning the heating level
switch 2 to "0" and pull the power plug out of the
socket. Wait until the device has cooled down - at
least 10 minutes.
Check the air inlet and air outlet holes. Eliminate
the cause of the overheating before you restart the
device.
CAUTION! Usually the device never gets
overheated without cause! If it gets too
hot, there is a danger of fire!
12 GB/IE/NI
Check whether the device is able to give off
the heat properly: Is the device covered with
anything? Or, perhaps, it is too close to a wall
or other obstacle? Check whether the grids on
the front or rear side are free of dirt and not
covered. Is the fan blocked?
If possible, eliminate the cause of the problem
or contact the service hotline (see chapter
"Service").
Please note: If the overheating protection is
triggered for the second time, you should turn
OFF the device and contact the service hotline
(see chapter "Service") - regardless if you have
found the cause of the problem or not.

4.5 Tilt Protection

This device is equipped with a tilt protection 1 . It
is located at the bottom of the unit. If the device is
inadvertently knocked over or subjected to a strong
tilt during operation, the unit switches off automati-
cally. The unit only works in upright position.
5. Maintenance, Cleaning
and Storage
Always disconnect the power plug when the
device is not in use and before any cleaning or
in the event of operating faults!
Clean the device only when it is turned OFF and
in a cooled condition.
Ensure that no moisture penetrates into the
device in order to avoid irreparable damage.
Clean the housing with a soft dry cloth only. Do
not use aggressive and/or abrasive cleaning
agents.
Remove dust deposits from the protective grille
with a vacuum cleaner.
Store the device in a dry room.