Table of Contents
Advertisement
3 SETTING UP THE APPARENT WIND MONITOR.
The Apparent Wind Monitor setup is done with a Multigraphic V2.4 or newer.
WARNING
To set up one of the wind sensors (Offset, True Wind table, mast height...), place the
selector on the relevant sensor. The Apparent Wind Monitor integrates the wind
tables for one sensor only. These tables are the same for all three wind sensors. The
wind tables are integrated in the Apparent Wind Monitor, which broadcasts them at
the installation start.
3.1 Setting up the mast height
The mast height is required for data denoising.
The value is the measurement between the mast head unit and the Apparent Wind
Monitor housing. It is expressed in metres and must be entered for each wind
sensors' setup.
Entering the value "0" for the mast height results in disabling the denoising function.
The mast height setting is done in the AWS menu.
3.1.1 Setup with a Multigraphic
Press and hold
to access the menu from which you can select
to display
the "Sensors" page.
+
+
5
65_Apparent_Wind_Monitor_FR_11
Advertisement
Table of Contents
